Chrysler Repair: cluster removal, steering column, instrument panel

Question
Hey Roland,
Can you email cluster removal directions for 98 T & C.
Thanks for your time.
Andy

Answer
Hi Andy,
I assume the prndl indicator is controlled electrically, otherwise let me know as the procedure is a little different.
No special tool needed. You begin by removing the main bezel that is surrounding the cluster.
Remove the steering column cover
Remove over steering column bezel
Remove left end cover of dash
Remove screw at left end of bezel and headlamp switch
Remove screws holding cluster bezel to instrument panel from each side of steering column
Disconnect strip holding cluster bezel to instrument panel from above right vent louver
Separate bezel from panel
Disconnect wires from back of bezel.
When installing take care not to push on louvers, and use care when reattaching clip to louver

Then remove screws holding instrument cluster to instrument panel
Rotate top of cluster outward
Remove cluster
Disconnect wire from rear of cluster.
Install is the reverse, put bottom in first, attach wire, then rotate top back into place.

Roland