Chrysler Repair: misfire codes, caps and plugs, valve models

Question
QUESTION: i have a 99 sebring limited convertible. it's throwing
codes p0300, p0301 so on. general misfires and specific
misfires on cyl's 1,2,3 and 5. i have had the distributer,
rotor, wires, caps and plugs replaced. reset the system,
and it throws the codes again within 30 miles.

ANSWER: chrysler has a tsb for that  replace the egr  use a chrysler one.

---------- FOLLOW-UP ----------

QUESTION: i cannot find that tsb, do you know the number of it?
i should also probably mention the car runs fine, no rough
idle, no sputtering, no lack of power. just keeps coding
every 30 miles or so.

Answer
NUMBER: 18-020-01
GROUP: Vehicle
Performance
DATE: Aug. 17, 2001



SUBJECT:
Rough Idle, Hard Start, Start & Stall
OVERVIEW:
This bulletin involves installing a revised EGR valve.
MODELS:
1995 - 2000 (JA) Breeze/Cirrus/Stratus
1996 - 2000 (JX) Sebring Convertible
NOTE: THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH A 2.5L ENGINE.
SYMPTOM/CONDITION:
Vehicle may intermittently exhibit any of the following conditions:
• Rough engine idle.
• Hard start or long crank after hot soak.
• Start and stall when started with cold engine.
• Diagnostic Trouble Code (DTC) P0300, Multiple Cylinder Mis-fire.

04287646AC Valve, EGR