Chrysler Repair: 2000 lhs 3.5 starter replacement instructions, negative battery cable, starter solenoid

Question
how do i change the starter

Answer
STARTER
REMOVAL
Disconnect and isolate the battery negative remote cable from remote ground post Negative Battery Cable Remote Terminal
Raise vehicle.
Remove three bolts attaching starter to engine Starter - 3.2 / 3.5L Engine
Remove battery positive feed wire from starter.
Remove starter solenoid assembly from transmission housing. Position the starter to gain access to the Connector Positive Assurance (CPA) wiring connector.
Position jack stand beneath engine and slightly lift to relieve pressure from left engine mount.
Remove three left engine mount mounting bolts from engine block.
Jack engine up slightly to give more room to maneuver starter assembly.
Slide rear of starter motor out between catalyst and engine mount.
Disconnect posi-lock starter solenoid connector.
Remove the starter from vehicle.
INSTALLATION
For installation, reverse the above procedures. Clean corrosion/dirt from the cable and wire terminals before installing wiring to the solenoid.

Reconnect posi-lock connector right after starter is placed into position