QuestionI previously asked about a 2002 sebring convertible but failed to include it was a 2.7 liter engine. My question was where was the thermostat and is there instructions or diagrams available?
Answerif u want pictures grab a manual
REMOVAL - 2.7L
Disconnect negative cable from remote jumper terminal.
WARNING: DO NOT REMOVE PRESSURE CAP OR ANY HOSE WITH THE SYSTEM HOT AND UNDER PRESSURE BECAUSE SERIOUS BURNS FROM COOLANT CAN OCCUR.
Drain cooling system (Refer to 7 - COOLING/ENGINE - STANDARD PROCEDURE).
Raise vehicle on hoist.
Remove right front wheel and belt splash shield.
Remove accessory drive belts (Refer to 7 - COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL).
Remove lower generator mounting bolt.
Lower vehicle.
Disconnect generator electrical connectors.
Disconnect AC clutch and AC pressure sensor electrical connectors. Reposition wiring harness.
Remove oil dipstick and tube. Plug hole in oil pan where dipstick tube mounts with water tight stopper.
WARNING: IF HOLE FOR DIPSTICK TUBE IN OIL PAN IS NOT PLUGGED, COOLANT WILL ENTER OIL PAN. SERIOUS ENGINE DAMAGE CAN OCCUR.
Remove remaining generator mounting bolts. Remove generator.
Disconnect hoses at thermostat housing.
Remove thermostat housing bolts (Thermostat and Housing - 2.7L Engine).
Remove thermostat and housing.
