Chrysler Repair: Oil Pan Replacement, negative battery cable, oil drain plug

Question
Hi Kevin, I need to remove a oil pan on a 95 cirrus 2.5.What steps should I take? Thanks

Answer
OIL PAN
REMOVAL
Disconnect battery negative remote cable Remote Negative Battery Cable
Remove oil drain plug and drain oil Oil Pan
Remove engine support module. Refer to procedure in this section.
Remove dipstick tube.
Remove starter motor. Refer to Battery/Starter/Generator Service for procedure.
Remove engine to transaxle struts.
Remove transaxle inspection cover.
Remove oil pan.
INSTALLATION
NOTE: Oil pan to cylinder block sealing is provided with Mopar Silicone Rubber Adhesive Sealant or equivalent gasket material. See Form-In-Place Gaskets in Standard Service Procedures.

Apply sealant as shown in Oil Pan Sealing
Install pan and tighten screws to 6 N·m (50 in. lbs.)
Reverse removal procedure for installation.
Install correct amount of new oil.