QuestionQUESTION: My window stopped working today. I wanted to take the door panel off to have a look at it but can't. I removed the 3 screws I could see but could not remove the door. The window just stopped working without any trouble leading up to it. The other side works.
ANSWER: do a search on here I have posted several times how door panel removal for your van.
---------- FOLLOW-UP ----------
QUESTION: I did see something on this but I did not think it applied to my 2003 van. I did remove the 3 visible screws but the panel did not come off. I do not have a book on this but will look for one. I'm assuming there is a screw somewhere that I cannot see.
AnswerREMOVAL
Remove the plug and remove screw attaching door pull cup to inner door panel.
Remove switch bezel and disconnect power window/memory switch.
Remove screws attaching trim panel to door from below map pocket.
If equipped, remove window crank. (Refer to 23 - BODY/DOOR - FRONT/WINDOW CRANK - REMOVAL)
Remove screw holding door trim to door panel from behind inside latch release handle .
Disengage clips attaching door trim to door frame around perimeter of panel.
Lift trim panel upward to disengage flange from inner belt molding at top of door.
Tilt top of trim panel away from door to gain access to latch linkage.
Disengage clip attaching linkage rod to inside latch release handle (INSIDE DOOR HANDLE LINKAGE).
Separate linkage rod from latch handle.
Disconnect the power door switch, courtesy lamp electrical connectors.
Remove front door trim panel from vehicle.
