Dodge Repair: 2004 intrepid fuel pump replacement, drb scan tool, tank pin

Question
How do you put the gas tank back into a 2004 dodge intrepid once you have replaced the fuel pump

Answer
same way u took it out.
INSTALLATION
Raise the fuel tank on the transmission stand (FUEL TANK).
Install fuel pump electrical connector into hole in the body.
Connect wiring harness to fuel tank pin, if removed (HARNESS ON TANK PIN).
Connect wiring harness to heat shield, if removed (HARNESS TAB ON HEAT SHIELD).
Connect the purge and vent lines (Fuel and EVAP Lines).
Raise tank into position and install tank straps.
Install the fuel filler tube and tighten the clamp (Fuel Filler Tube).
Reposition the stabilizer bar and install bolts.
Lower vehicle.
Connect the fuel pump electrical connector that is under the rear seat (Electrical Connector).
Install the rear seat, refer to the Body section for more information.
Connect the battery cable (Battery Cable).
Fill fuel tank. Use the DRB scan tool to pressurize the fuel system. Check for leaks.