Pontiac Repair: chevy suburban (2003), power window regulator, chevy suburban

Question
i need to know haw to change my power window regulator. thank you

Answer
Hi
first remove the door panel
(Remove the door handle bezel. Refer to Door Inside Handle Bezel Replacement .
Remove the door trim panel upper extension. Refer to Upper Extension Trim Panel Replacement .
Using a suitable flat bladed tool, gently pry the manual lock lever from the door trim panel.
Remove the trim panel screws
•  Remove the screw  from within the opening where the manual door lock lever resides.

•  Remove the screw from the opening in front of the armrest.

•  Remove the screw located beneath the map pocket, if equipped.

Carefully slide the trim panel up in order to release the retainers from the door.
Disconnect the electrical connectors)

Then remove the regulator/motor assy

(Raise and support the window glass.
Remove the trim panel.
Remove the water deflector.  
Disconnect the harness from the electric window motor assembly.
Remove the 2 bolts that hold the window glass to the regulator.
Remove the bolts from the window regulator.
Remove the window regulator assembly from the door by folding both sides of the window regulator assembly together.


Then the motor from regulatorand install yuor motor on the new regulator. I leave one screw in regulator where motor will go so it does not unwind(ruins regulator)

I hope this helps
Good Luck
God Bless
Pawl