Small Engines (Lawn Mowers, etc.): 1996 murray riding mower, switch jumper, jumper wire

Question
I have a 1996 riding lawn mower and I was having problems with it starting.  I have put in a new battery, selonoid, and starter, and when i turn the key over it wont even make a noise or act like it wants to start.  I just mowed last week.  I have also replaced the blade belts.  What else could it be preventing my mower from getting any fire?

Answer
Hello Nathan:

This Sounds like a Safety Switch Problem. **PLEASE REMEMBER THAT THE INSTRUCTIONS FOR CHECKING THE SAFETY SWITCHES IS JUST THAT!!! FOR CHECKING ONLY. I NEVER Suggest a Mower be Operated with a Safety Device or Switch Disconnected or Bypassed. Now. On Some Model Mowers you can Simply Unplug the Safety Switch from the Harness. On Other Models you have to Place a Jumper Wire Between the Harness Terminals (on the 4 Post Switch Jumper from Same Color Wire to Same Color Wire). Check the Clutch/Break and the Blade/PTO Safety Switches First. Check the Seat Safety Last. Usually the Seat Safety is Not in the System for Starting the Engine. Just to Ensure Someone is in the Seat when Engaging the Transaxle and/or Blades.** Send me the Model Numbers Off the Mower, Please. With these I can Locate the Proper Manual and Better Assist you. If you Hit a Snag or this Does Not Correct the Problem,  I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Thanks.

Respectfully

John