Auto Glass: 80 series Landcruiser Wagon Side Slinding Windows, landcruiser glass

Question
G'day

I have one of the two side rear sliding windows smashed. I have replacement widow and latch, and I have cleaned up the tracks and mess from the smashed one, but I cannot work out how to get the "frame" out so I can slip the glass in and replace. Any ideas would be appreciated!

Cheers

Answer
Hi Glenn,

       I do not remember ever doing one of these sliding windows so I did a little searching and found this from:

http://forum.ih8mud.com/80-series-tech/253629-sliding-rear-window-removal-rust-s


MEANING: I Have never done one of these so do not leave trash feedback Ratings when people try to help you!!!

Quarter Window Glass Removal
1. Remove floor mat support plate (remove 5 screws and the plate)

2. Remove Quarter Trim
a. insert a screw driver between the retainers and quarter trim to pry it loose
HINT : tape the screwdriver tip before use
b. remove the quarter trim

3. Remove rear pillar garnish
a. insert a screwdriver between the retainers and the 1/4 trim to pry it loose

4. Remove rear seat side garnishes and scuff plate
a. insert a screwdriver between the retainers and the body to pry it loose
HINT : tape the screw driver tip before use

b. pull out the side garnish

5. Remove the vent louver and 1/4 belt moulding
a. remove the nut from the vent louver
b. insert a screw driver between the retainers and body to prit it loose
c. pull out vent louver
d. pull out the clips from the edge of the panel, and remove the moulding

6 . Remove the 1/4 window glass
if reusing the weatherstrip:
a. using a screw driver loosen the weatherstrip from the body
NOTICE: be careful not to damage the body

b. pry the lip of the weatherstrip outward from the interior part of the body flange
c. pull the glass outwards and remove it with the weatherstrip.

if using new weatherstrip:
a. from outside of the vehicle, cut off the weathestrip w/ a knife
NOTICE: do not damage the body and the glass

b. push the glass outwards and remove the glass
c. remove the remaining weatherstrip.
         
         1/4 window glass disassembly

1. remove the center weatherstrip (remove the screw and the weatherstrip)

2. remove the 1/4 window glass
pull up the sash and remove the 2 glasses

3. remove 1/4 window glass run from sash
4. remove 1/4 window weatherstip from sash

Quarter Window Glass Assembly

1. install 1/4 window weatherstrip on sash , see pic, sorry
NOTICE: if weatherstrip is hardened, it may develop leaks, use a new one if possible

2. Install 1/4 window galss run, as shown
3. install 1/4 window glass
pull up on the sash and install the 2 glasses

4 install center weatherstrip
install weatherstrip w/the screw up your ass

Hope This Helps!      Derek =D

MOBILEGLASSS@AOL.COM