Auto Parts: solenoid operating voltage, pep boys, signal wires


Question
What is the operating voltage of EGR vacuum solenoid part number 191-906-283-A (or Hella wo133-1807739) for a 1998 jetta glx 2.8L?  The solenoid applies vacuum to Kombi valve. I believe the air pump runs only 65 sec on cold start and after a 20 second delay for 5 seconds during a hot start. This would make me think that the applied voltage may be 12 volts rather than a pulse width modulated by PGM which would be for a car that varies the EGR continously

Answer
Hi Ed,

Sorry for the delayed response but my computer has been down for the last few days.

To answer your question, honestly, I have no clue. I would never flood a wire coming from a PCM/ECM with 12 volts as signal wires usually only carry fractional-voltages and a full 12vt hit may damage what you are trying to test. I wish I could help you more.

Looking for a reputable service technician? My advice on finding a good technician is: Steer clear of the dealership and 'chain' stores like Firestone, Sears, Pep Boys, Monro Muffler/Brake, Midas, etc. as they usually only employ ONE ASE Certified Tech just so they can say they do and chances are, that guy is the asst. manager or manager and is not in the store to diagnose/repair vehicles anyway. Find a service location in the link below or get some names out of the yellow-pages and do a drive-by. Garages that employ ASE Certified Technicians will be marked with the 'Blue-Seal' insignia. If unsure about whether a place employs Certified Techs, just ask to see their credentials. ALL ASE Certified Technicians will be PROUD to show and display their certificate(s).

Thanks for the question, I hope this information was helpful to you.
Fred
Knucklebusters Used Auto & Truck Parts, Inc.
www.knucklebusters.us
570-453-0910
"Re-use is the best form of recycling" Help us recycle by purchasing used parts from us!
Looking for an ASE Certified shop near you? ASE Certified Technicians are the BEST of the BEST!
Click here: http://www.ase.com/bluesealsearch/locator.php