QuestionI have a 2000 Nissan Xterra and I do not have any power going to my engine. I have a factory alarm system. Trying to find out how do I reset the system so that my car will start. The inside, outside lights come on however not the engine. The car do not turn over either. The starter, battery was check and both were ok.
Please advise
AnswerHmmmm, Likely to be factory if it's the car's
own horn honking.
However, if it's a siren and flashing lights,
it's after market.
Ok, here's what I know...
Normally, putting the key in the drivers side door lock,
turning to the left, then to the right all the way
will unlock and disarm/reset the "OEM factory"
alarm system.
If it's after market, try the following:
PUT IGNITION KEY IN IGNITION,
KEY ON TO JUST BEFORE CRANKING THE ENGINE.
PRESS IN AND HOLD VALET SWITCH FOUND UNDER THE DASH
AREA UNTIL YOU GET A RESPONCE FROM THE ALARM.
KEY OFF.
This should toggle the alarm in and out of
valet/override.
If toggle type switch.
KEY ON, FLIP SWITCH, KEY OFF,
START THE CAR.
If this is not solving the issue,
please go to the site we set up
to deal with all of these requests
for disarming the security in any
given vehicle. It is a liability to
publicly share that level of information
here at ALLEXPERTS.
Obviously, posting this sort of sensitive information
for all to see and implement is not a good idea.
Since we are liable if my info is used to perpetrate a crime,
we sell it for a very modest fee, and keep track of who buys
it in case it should come back to us for review.
If wanting this information to solve you disarm issue.,
please go to DISARMALARM.com so I can get you the
info you require to fix your particular situation.
I hope to be able to help you
with this problem.
Robert Martin-
ALARMTEKONLINE-
DISARMALARM.com
