Car Alarms: Fusion F-2000 Car Alarm, flip switch, start the car

Question
Have this installed in a Toyota that I purchased.  It was functioning normally and the other night I statred the engine, the LED statred flashing, I turned the engine off and now when I try to start the engine the alarm goes off, car battery has plenty of juice and the valet switch doesn't seem to do anything.  Any suggestions short of removing the alarm?

Answer
Hmmmm,
Make sure you do the procedure correctly.
Might have missed a step:

PUT IGNITION KEY IN IGNITION,
KEY ON TO JUST BEFORE CRANKING THE ENGINE.
PRESS IN AND HOLD VALET SWITCH
UNTIL YOU GET A RESPONCE
FROM THE ALARM.

KEY OFF.

This should toggle the alarm in and out of
valet/override.

If toggle type switch.
KEY ON, FLIP SWITCH, KEY OFF,
START THE CAR.

I hope this solved it for you.
If not. look forward to removal/replacement
or repair.

ALARMTEK