Car Alarms: 2000 Dodge Neon alarm no start, dodge neon, flip switch

Question
QUESTION: I bought my 2000 Dodge Neon from a private owner. My alarm was always over responsive until one day it came on and never came on again. I never really cared much for it until recently. I was doing a routine maintenance on the vehicle and I cleaned the battery terminals. When I was finished and hooked up the battery again lo and behold the alarm kicked in and would not turn off. I found the horn and disconnected it but the alarm is still active and the car apparently has a kill switch on it. I cannot turn on my vehicle with the alarm on. Please help

ANSWER: Try the following:
PUT IGNITION KEY IN IGNITION,
KEY ON TO JUST BEFORE CRANKING THE ENGINE.
PRESS IN AND HOLD VALET SWITCH
UNTIL YOU GET A RESPONCE
FROM THE ALARM.

KEY OFF.

This should toggle the alarm in and out of
valet/override.

If toggle type switch.
KEY ON, FLIP SWITCH, KEY OFF,
START THE CAR.

I hope this solved it for you.
If not. look forward to removal/replacement
or repair.

ALARMTEK

---------- FOLLOW-UP ----------

QUESTION: This did not solve my problem Im going to have to remove the alarm system but I would like to know how the system deactivates the start mechanism and if I may be able to bypass the function. Any suggestions as to how to remove it?

Answer
Please go to my forum at www.INSTALLSUPPORT.com
Robert can help you in more depth then I
can go into here.

Just restate this inquiry there.
He's very good about getting back
to folks quickly

INSTALLSUPPORT.COM

If anyone can guide you on this,
he's your man.

Good luck.

ALARMTEK