QuestionI have a Pursuit car alarm on my 98 Camaro. Recently, my car battery went dead. My husband jumped it and got it started. Since then, the alarm will not set. It used to make a beep sound for setting and disarming. Now there is no sound. Does something need to be reset for alarm to work? Thanks.
Answer
override switch
It appears from your expaination, that the
after market car alarm is in service mode.
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the
left of the leg drilled into a hidden away spot,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)
This should reset the alarm.
Just Repeat these steps to place it
back to valet mode.
That should do it.
Let me know what happens.
ALARMTEK
INSTALLSUPPORT.COM
