Car Alarms: Dodge Durango Keyless entry, dodge durango, dash area

Question
After changing the battery in my Durango, now my keyless entry doesn't work. Nothing on the key will work, the unlock, lock, or panic, but it was all working fine before we changed the battery. Could this be connected?

Answer
Seems the system is reset, and needs
to be done again.

Probably when it lost power.

Right, Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/override
button, found under the dash area, usually to the left
of the leg, drilled into a plastic panel.
Might even be part of an on glass antenna
in the windshield if it's a remote starter,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in opposite direction,
key off.)

This should reset the alarm and allow you to
use the remote. If not, then you will need to locate the
alarm/keyless manufacturer to get programming information.

Good luck.

ALARMTEK