Car Alarms: Truck Alarm, shock sensor, flip switch

Question
I replaced the battery in my 94 Ford F250 and now the alarm will not disarm. I tried disconnecting the battery and putting the key in the on position and that did not work. I would like to disconnect the alarm totally so this does not happen again.
The shock sensor is says pro 9094c.
Thanks!

Answer

valet Hmmmm,
Make sure you do the procedure correctly.
Might have missed a step:

PUT IGNITION KEY IN IGNITION,
KEY ON TO JUST BEFORE CRANKING THE ENGINE.
PRESS IN AND HOLD VALET SWITCH
UNTIL YOU GET A RESPONCE
FROM THE ALARM.

KEY OFF.

This should toggle the alarm in and out of
valet/override.

If toggle type switch.
KEY ON, FLIP SWITCH, KEY OFF,
START THE CAR.

I hope this solved it for you.

ALARMTEK