Car Alarms: Lost keyless entry remote to 95 Sebring, valet mode, dash area

Question
QUESTION: I lost the keyless entry remote to my 95 Chysler Sebring, I am afraid that if I open the door without the remote the alarm will go off. What should I do?

ANSWER: Without sounding dumb, get new remotes immediately. :>(
That's a no brainer. Until then, see the past posts
for valet override and see if they will
apply to this car.

Good luck.

ALARMTEK

---------- FOLLOW-UP ----------

QUESTION: Okay I will try that but my only concern is that when i bought the car it had the alarm system on it and it's not the factory alarm, so will what you said still work?

Answer
Right, Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/override
button, found under the dash area, usually to the left
of the leg, drilled into a plastic panel.
Might even be part of an on glass antenna
in the windshield if it's a remote starter,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in opposite direction,
key off.)

This should reset the alarm and allow you to
go on your way.

Just Repeat these steps to place it
back to valet mode.

That should do it.

Good luck.

ALARMTEK