Car Alarms: SCYTEK CAR ALARM 4000RS 1 car, toyota caldina, resident technicians

Question
Dear Sir

I have question

I installed the alarm in my Toyota Caldina 2000 Model, it working, a few wires no idea where to connect them, please help

gray wire -  i have not connected, I dont no whats auxilary 1
Orange - i have not connected, no idea where to connect, Armed Output (-) 500 mA. The Orange wire provides a ground output while armed to
activate a relay for starter defeat and anti-grind protection

Blue Orange - Not Connected - No idea where to connect, Ground When Running Output (-) 500 mA. Connect to an optional factory security
bypass module if required.

Black white - Not connected - Please advise where to connect

Black gray - Not connected - no idea where is the vehicles tach wire,
Tach Input. Connect to the vehicle’s tach wire or a fuel injector wire if the tachless
mode does not provide satisfactory operation.

White Violet - not connected, No Idea where to connect - Factory Disarm Output (-) 500 mA. The Violet/white wire provides a ground output
on disarming and before remote starting to disarm a factory security system. Connect to the wire that
requires a ground pulse to disarm the factory security system.

Violet - hopefully not used in toyota

Green White - I have disconnected the said wire, as when i enter into the car, i switch the ignition on, and press the break padel, the car shuts down.and i have connected correctly as per the instruction Brake Input (+). Connect to the wire that shows +12V when pressing the brake.
The Green/white wire is a safety shutdown wire that must be connected.

I will appreciate your help on the said

Regards
Zulfiqar  

Answer
Sorry but I don't do full install support here.
The best thing is to go to my installers
forum at www.installsupport.com and see if
my resident technicians there can assist
with this project.

Unfortunately this is more free information
then I provide here at ALLEXPERTS.

Good luck there.

ALARMTEK
WWW.CARALARMMAN.COM