Car Alarms: Car Alarm(Kill Switch) Prestige Alarm 2000 Dodge Intrepid, valet mode, prestige alarm

Question
The kill switch on my car has kicked in.  My car will not start at all.  The lights, radio and signal all work, but the car will no turn over.  How do I reset my alarm to get it out of (kill switch) this mode?

Answer
Right,
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the left
of the leg, drilled into a plactic panel,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to valet mode.

That should do it.

Good hunting.

ALARMTEK