Car Alarms: car starter not connecting, alarmtek, fcc id

Question
im not sure as to the make of the starter it only has an id # on it : fcc id:nahrlcd4 anyways when i press the button to start it nothing happens...i tried a new battery and still dosen't work...any insight would be appreciated. thanx!

Answer
It appears from your expaination, that the
remote starter is in service mode.

Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the
left of the leg drilled into a hidden away spot,
(can be part of the antenna on the window glass too)
until the installed LED (s) (the blinking light (s))
in your dash area goes off.

This should reset the system.

Just Repeat these steps to place it
back to valet- override mode.

I hope this helped.

ALARMTEK
INSTALLSUPPORT.COM