Car Alarms: Automate am9, keyless entry systems, prong plug

Question
hi i have an automate am9 remote start and i have a couple questions for you.. my first one is about the status led that comes on when the alarm is set.. When my alarm was installed i didnt use the factory led that came with it and i ended up losing it. I since bought an LED for car alarms that has the 2 prong plug and i plugged it in and it didnt work.. i turned the plug backwards because i figured the LED had polarity, and also, nothing>> i am wondering if you knew what voltage these LEDs work off of, so i could possibly try a different LED.. my second question is, my alarm is hooked up to auto start, and ive recently had problems with it when it... it wont start when i turn my key over.. i have to remove the fuse then  re-install the fuse, then turn the ignition off then back on for it to work properly, but once its started, i have to repeat these steps.. thanks for the help, Jon

Answer
Your question triggered this
automated responce to a
DEI equipment support inquiry...

Sorry, due to a mutual agreement
between Directed Electronics & myself,
Questions or, support for DEI car alarms,
or remote start/keyless entry systems
will NOT be provided here.

(Please take note of the disclaimer
I posted at the ALLEXPERTS.com site
www.CARPROTECTOR.com )

You can either try www.directed.com or,
take this question to my online 12 volt
installation Technican forum
at www.installsupport.com.

Many of the technicians there can
assist you with this issue.

Good luck.

ALARMTEK