Car Alarms: titan car alarm reset?, valet mode, dash area

Question
I just installed a new battery to my 1994 Honda Accord and set my Titan alarm
system (not from car manufactory) off. I tried to press the remote control
buttons "I" and "II" with no avail. Every time I open the car door or turn on the
engine it will set off the alarm.  Can you help me how to reset the system back
to default mode?

Answer
Right,
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the left
of the leg, drilled into a plactic panel,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to valet mode.

That should do it.

ALARMTEK