QuestionMy Mountaineer has a factory alarm installed. I have since replaced the ignition lock cylinder, doing so I had to have the battery disconnected. My keyless entry still works, but it no longer disarms or arm the alarm. I can start the car if I press and hold the driver unlock to disable the immobilizer. I would like to get my alarm functioning again. I am not sure if leaving it unplugged has unsynced it from the keyless entry, or if the module is now defective. Any advice or help would be appreciated.
AnswerAh, sorry I do apologize,
but my expertise is in after
market vehicle alarm systems.
If yours is indeed a factory system,
I suggest talking to one of the
techs in my Forum about this one.
Please go to www.INSTALLSUPPORT.com
re state this inquiry there.
I am certain my guys will be
happy to assist if possible.
I hope you find the answer/solution
to your issue.
Regards,
ALARMTEK/CARPROTECTOR.COM