QuestionQUESTION: I have a problem when I start my p/u the auto door locks relay or solenoid buzzes about 2 seconds before locking and after killing the engine it does the same before unlocking the doors. Can you help me repair or tell me how to disconnect the door locks.
ANSWER: Ok for now, it should be fairly easy to try
to disarm it.
look under the dash area for a button or,
a toggle switch. When you locate it, turn on the
ignition key, press and hold in the button (little
spring loaded micro button, red or black)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE
This stops the alarm except for the keyless
entry if installed. Once in Valet mode,
it will allow the car to start and operate
like there was no alarm at all.
That should solve the troubles for now but I strongly
suggest a technician evaluate this for you to
determine the problem.
ALARMTEK
---------- FOLLOW-UP ----------
QUESTION: I would really like to keep the alarm working and disconnect the auto lock. I found the motion sensor and the valet/overide button and If possiable I would like to just cut a wire and disable the auto lock.
Thanks Doug
AnswerNot that easy. There are blade type seperators
in the alarm brain You need to power down,
(unplug the brain box harness) open the sliding door
that covers these blades, and either remove or install one
to make the auto arm/active arm mode change.
Then once powered back up, the system will
only arm when you choose to make it so.
Go to www.microalarm.com click on the
support link and download the manual to
see what you need to do to accomplish your goal.
Good luck.
A.
