QuestionWhat wire do i cut to disable the alarm on my 1996 camaro rs, and without blowing the air bags?
Answer:>( Bad news I am afraid.
There is no wire to cut.
You have bigger issues if it's malfunctioning.
This vehicle has a the PASSKEY 2 key
based engine disabling system.
You can attempt to put the key in the ignition,
turn it on to just before cranking and then leaving
it that way for 10 mins. After that,
some PASSKEY systems will re learn the code
and allow for starting. But if not, the system
will either need to be seen by GM or, a bypass module
is required to circumvent.
If left unchecked though, it will continue to lock down
the fuel injector rail, and you will need to tow
it in to GM for evaluation, and resetting anyway.
Bothersome, but can be fixed.
I suggest the PLJX bypass kit to get around
this issue. www.PASSLOCK2.com
This Passkey Bypass Module is designed to momentarilly
allow the engine to remote start by sending a proper
coded pulse to open the fuel rail passlock injector
cut off circuit.
The output from an alarm/remote starter
would then shut down the pulse, once it has detected
the engine has engaged, and preserve the integrity
of the passlock system.
That is it's designed purpose.
However, in your case, this input wire on the PLJX
bypass module, instead of going to a momentary
ground pulse from an alarm/remote starter,
would go to a constant chassis ground, through
the bypass module, grounding out the PASSKEY.
The PASSKEY would then always be bypassed as long
as that wire is chassis grounded.
The catch here is that the car engine
MUST start to program this module or it
won't work.
I can not speak about a damaged passkey system,
like if a thief has destroyed it, because I do not
get into this part of GM'S security application.
But as a happy coincidence to installing
after market remote starters, this does work on bypassing
passlock in most all GM vehicles we've run into,
including your year GM vehicle as well.
Also, this is a self learning, resistor sensing
and adjusting module. Once the PASSKEY wires have been tapped,
you would press the program button to learn,
and it does. The car should then allow start
with any hardware store key.
You might want a car alarm installer to do this
for you, the fair rate being around 50. to 75.
for labor.
Copy cut n paste the following payment link:
https://www.paypal.com/xclick/business=installsupport%40aol.com&item_name=1-GALAXY+PASSKEY+BYPASS+MODULE&item_number=1-GALAXY+PASSKEY+BYPASS+MODULE&amount=69.95&no_note=1¤cy_code=USD
if you want to buy yours now,
or, go to the site link below to learn more
about your truck's system, and buy the
appropriate unit there.
Kind Regards,
Robert Martin-ALARMTEK/CEO
Master Technician
Mobile Security Electronics
www.PASSLOCK2.com
