Car Alarms: bypass car alarm, valet mode, dash area

Question
I put my remote alarm control in the washer to clean & it's now destroyed & I can not start my car, I tried disconnecting the battery to reset it but that won't work, can someone give me some guidance, thanks.    
P.S. Just kidding!!! I put it in the washer by mistake, ih, ih, ih, ih.

Answer
Expensive boo boo. :>(

Ok, try this.
locate the valet over ride switch and put
it into over ride for now.

It's usually to be found under the dash area.
Look for a button or, a toggle switch.
When you locate it, turn on the
ignition key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE

This stops the alarm except for the keyless
entry if installed. The next step is to
either remove the alarm or, try to identify,
and get new remotes for it.

But once in Valet mode, it will allow the car
to start and operate like there was no alarm at all.

Let me know how it goes.

ALARMTEK
CARALARMMAN.COM