Questionhi, i lost my remote (fcc id:777k for Silencer Alarms, now i can't start my car and i can't buy one the same as old one. please give me some instructions.
regards
AnswerSorry, no. This is not part of
the voluntary service or information
that I provide here.
If you did not read the BIG note
I left at ALLEXPERTS.com concerning
programming issues, please look again
at the ALLEXPERTS.COM-ALARMTEK front page
www.CARPROTECTOR.com .
I do not sell replacements remotes,
or provide programming for remotes,
or supply info on feature settings
for manufacturers car alarm systems.
Still true.
Sorry about that.
But to try to overide it currently,
put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.
(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)
This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.
At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.
Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.
That should do it.
ALARMTEK
CARPROTECTOR.COM
