Car Alarms: code alarm elite 4500 uninstall, dash area, flip switch

Question
I bought a car that had a "Code Alarm Elite 4500" alarm system previously installed. One day, I opened the door and the alarm went off. I haven't been able to shut it off, start the car, or anything else since. Please tell me how to uninstall it. Thank you.

Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to user mode.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart for
the vehicle, and reverse engineer it wire
by wire, until it's safely removed.

If it does not work out this way, you will have
to replace the system with one you know how
to operate and what to expect.

Let me know what happens.

ALARMTEK
INSTALLSUPPORT.COM