Car Alarms: bypass car alarm, side kick panel, alarm security system

Question
QUESTION: Hi
Can you advice me how to bypass a factory fitted alarm on a kia sportage 1997 model

ANSWER: It's likely to be an after market system.

To try to disarm it,
look under the dash area for a button or,
a toggle switch. When you locate it, turn on the
ignition key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE

This stops the alarm except for the keyless
entry if installed. Once in Valet mode,
it will allow the car to start and operate
like there was no alarm at all.

The next step is to either remove the
impact/shock sensor or, try to turn it down.
This might require a local technician to
identify it, and affect neccesary service for you.

Repeat steps to put into user mode.

That should solve the troubles.

Let me know how it goes.

ALARMTEK
CARALARMMAN.COM

---------- FOLLOW-UP ----------

QUESTION: hi and thanks very much for the reply
It is a factory fitted alarm.the alarm module is located in the passenger side kick panel.I can start the car by doing a sequence of counting of the led in dash  .but this takes about 30 seconds and its a pain if my wife stalles the car in traffic,she will need to do the whole sequence again.I would like to disconnect the dam thing .do you have any other suggestions
Thanks

Answer
That's a bit of a problem here.
Because yours is a "FACTORY" or, OEM
(original Equipment Manufacturer) "alarm/security" system,
then the disabling procedure info for any given
specific vehicle is now deamed to be too sensitive to
publish here (as suggested by ALLEXPERTS administration.!).

So, to comply, as of March,22 08, this service is no longer
part of the volunteer information I can offer for free here at
ALLEXPERTS.com . Specific OEM/FACTORY alarm disarm/disabling
info is now available ONLY at the WIREWERX.

My installation wiring charts provide the proper wire colors,
polarities, and locations to install a keyless entry,
remote start or, car alarm system into any given vehicle,
or if just trying to disarm/disable your factory/OEM system,
there is a link there to get a tutourial on how to do it yourself
for only $2.99.

I hope you can appreciate the legal reasons behind not
providing this info any longer to just anyone who asks
for general consumption. By doing it this way, I'll
get a record of payment and a name/email address as
a stop gap to help prevent any unauthorized disabling of
your system or anyone elses, by a would be car thief!

Please go to the WIREWERX so I can get you the
info you require to fix your situation.

Good luck with this issue.

Robert Martin-ALARMTEK AUTO ALARM
The WIREWERX= www.WIRINGCHARTS.com