Car Alarms: Executive keyless entry & security remote, change batteries, dash area

Question
QUESTION: lock/unlock mechanism won't allow truck to start- who would disconnect in Seattle?
can't find phone #/website for Executive

ANSWER: You'll need to set off the alarm for a few seconds.
Then, look under the dash area for a button or, a toggle
switch. When you locate it, turn on the ignition
key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.

At this point. the alarm would have reset.
If this had a starter kill relay installed,
it would now be opened, and the engine would
turn over when tried.

You would repeat these steps to go back to
user mode to see if this was corrected.

But if it does work, I'd keep it this way, and
replace the alarm asap with one you know and
understand how it operates for the best overall
experience.

Let me know if it works for yours.

ALARMTEK
INSTALLSUPPORT.COM

---------- FOLLOW-UP ----------

QUESTION: don't have alarm, just keyless entry that stopped working in October '07-have to use key to open door. As of 3 days ago when try to start truck, need to push unlock then lock button once key in ignition.
# for Executive Keyless or out of business?
just want to disconnect remote so can start truck-probably not worth fixing-did change batteries in remote
thanks

Answer
Not certain if they are out of business,
but try this:

Look under the dash area for a button or, a toggle
switch. When you locate it, turn on the ignition
key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the systemm flashes the lights 1 time.
This should over ride the system, and only
the keyless entry part, if installed, would still
be operating.

The LED (light emiting diode) light in the dash
should also go on solid.

This solves the problem for now.

Then if you want to remove it, take it to a local
after market alarm dealer and have it done there.

Have a nice afternoon.

ALARMTEK
INSTALLSUPPORT.COM