Car Alarms: UNGO alarm uninstall, valet mode, dodge 1500

Question
My used '98 Dodge 1500 PU truck came with a UNGO alarm system that (per my mechanic) is why my truck won't start. Good fire/fuel. Pulled  just about every fuse he could find but no effect. Any suggestions will be greatly appreciated. Thanks

Answer
To try to disarm it,
look under the dash area for a button or,
a toggle switch. When you locate it, turn on the
ignition key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE

This stops the alarm except for the keyless
entry if installed. The next step is to
either remove the alarm or, try to identify,
and get new remotes for it.

But once in Valet mode, it will allow the car
to start and operate like there was no
alarm at all. Repeat steps to put into user
mode.

Let me know how it goes.

ALARMTEK
CARALARMMAN.COM