Car Alarms: cain;tstart car alarm wont reset with the remote, 1997 ford taurus, jasper alabama

Question
i have a 1997 ford taurus it has an exective  security system my car battery went low and now after recharging the battrey my alarm is going off and i cannot reset it the remote is blinking but nothing happens i live in jasper alabama and nobody knows how to work on it i went to the ford dealership and they said it was an after market device and they dont work on it can i un install it myself and if so how or what can i do as i am in bad health and draw a small disability check any help will be greatly appriciated david uptain 205-387-9677

Answer
You'll need to set off the alarm for a few seconds.
Then, look under the dash area for a button or, a toggle
switch. When you locate it, turn on the ignition
key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.

At this point. the alarm would have reset.
If this had a starter kill relay installed,
it would now be opened, and the engine would
turn over when tried.

You would repeat these steps to go back to
user mode to see if this was corrected.

But if it does work, I'd keep it this way, and
then when possible, remove & replace it.

Let me know if it works for yours.

ALARMTEK
INSTALLSUPPORT.COM