Car Alarms: remove a car alarm system, car alarm system, valet mode

Question
i bought my car about 2 months ago, it is a 98 eclipse and i want to remove the car alarm system and now i cant get it to start, every time i turn the key the alarm goes off and all i want to is remove or reset it. it is a after market alarm i already contacted the dealership and talk to them, it is a after market alarm i dont know what kind it is i dont have the remote for it. i already read the owner's manual, i check the fuse, the battery and still my car still doesn't start.

i want to know how to just remove the alarm or should i go get it remove for 70 bucks...

Answer
You are correct, it is an after market system.
Probably dealership installed when
it was purchased originaly.

The shock/impact sensor seems to be the likely
culprit here.

It's usually to be found under the dash area,
blinking when anything taps on the underpanel.
Locate and either unplug or turn down.
To simply disarm it, locate and use the
valet/overide switch.

To start, look under the dash area for a button or,
a toggle switch. When you locate it, turn on the
ignition key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE

This stops the alarm except for the keyless
entry if installed. The next step is to
either remove the alarm or, try to identify,
and get new remotes for it.

But once in Valet mode, it will allow the car
to start and operate like there was no alarm at all.

Let me know how it goes.

ALARMTEK
CARALARMMAN.COM