Car Alarms: pursuit alarm, starter wire, dash area

Question
How Do I reset the alarm  battrey died and alarm has to be reset I have a push button type switch not a toggle

Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button,
in your dash area goes on solid,
and the siren chirps once.

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.

ALARMTEK