Car Alarms: car wont start, thanks a million, little spring

Question
First, after replacing cap. rotor and coil, I think my trouble may be in the immobizing part of my alarm (autopage xt-59).  I have already found the red button and pushed it in all kids of different orders.  Now the red light remains on but on the car still won't start.  The car turns over but no spark.  Am I correct in assuming that it is immobilzed?  Secondly, how do I reset it?

Thanks a million!

Answer
Gotcha, try to reset the alarm to default mode.

Press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid, or off depending on the mode.

At this point. the alarm would have reset.
If this had a starter kill relay installed,
it would now be opened, and the engine would
turn over when tried.

You would repeat these steps to go back to
user mode to see if this was corrected.

Let me know if it works for yours.

ALARMTEK
INSTALLSUPPORT.COM