Car Alarms: Hellfire car alarm, car alarm system, butt connector

Question
I am trying to remove a Hellfire car alarm system that is tied into my cars Ignition system, door locks and starter.  I have located the main alarm box but I do not know how to proceed from here.
The car is completely dead now and will not do any thing.

Answer
You should start with the notes on the car
to see which wire it's attached to is which.
www.wirewerx.com

Then the first thing you do is locate
the hellfire (now out of biz.) system's
orange wire ( (-) ground out when armed wire)
that has a relay that it's attached to,
then the installer inserted it inline on
your vehicle's starter wire setting up starter
kill.

Cut this assembly off of the vehicle's starter wire,
then attach the 2 free ends together with a yellow
butt connector. That should repair the starter.

After that, methodically remove the rest,
repairing as you go until you're back to
pre install condition, and happy.

I hope this was helpful.

ALARMTEK
CARALARMINSTALLER.COM