Car Alarms: Disconnect Viper, viper dealer, dash area

Question
I read the Viper note, but that mentioned programming. My daughter lost her Viper fob. Her spare factory key just sets off the alarm. Can you tell me how to get rid of the thing? It resides behind the radio, pain to get to. Also, is there an overide button?

Thank you - Ron

Answer
Gotcha, try to reset the alarm to overide mode.

Look under the dash area for a button or, a toggle
switch. When you locate it, turn on the ignition
key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.

At this point. the alarm would have reset.
If this had a starter kill relay installed,
it would now be opened, and the engine would
turn over when tried.

You would repeat these steps to go back to
user mode to see if this was corrected.

If no luck, please do contact a Viper dealer
for support on it as suggested.

I hope it helps.

ALARMTEK
INSTALLSUPPORT.COM