Car Alarms: all door unlocking using compustar, remote starter, toggle button

Question
QUESTION: I had RF-2W900 recently on my Rav4 and i see that there is no way to open passenger side door using compustar remote. Is this the desired  behavior? The manual doesn't talk about passenger door explicitly except that trunk open should open all doors also. In my case there is no trunk and trunk open actually opens just opens the driver side door.
I wanted to know the desired behavior and option before i talk to installer. Thanks for the help.

ANSWER: you need to have 2 unlock outputs and do a relay application
to make drivers door priority work. The remote starter MUST have
an unlock wire, and the designated passenger/all other door
unlock trigger wire to or it will not work.

See at www.relayhelp.com

ALARMTEK

---------- FOLLOW-UP ----------

QUESTION: just to be clear the current behavior is that it just unlocks/disarms the drivers door using button 1. If i press it again it arms/locks it back. With the 2 unlock output will it unlock the other doors if i press it again instead of locking it again? The problem i see that the same button is used to lock and unlock and it behaves like a toggle button. Can the same button be used to unlock all doors? Thanks for the help.

Answer
The unlock wire would need to be either a seperate trigger wire, or
the unlock wire would need to be able to first 1 pulse unlock
the drivers door, and within 2 seconds, press again and trigger
the others. It requires seperating the unlock wire and inserting
the 2 wires or the relay diagram I suggested.

The alarm has to have this second wire to make the function happen.
Contact your seller for clarity on this.

A.