Car Alarms: 93 jeep grand cherokee, jeep grand cherokee, grand cherokee

Question
i have a 93 jeep grand cherokee and we just did an engine swap and it starts with ether and it stops getting gas after 3 secs the lights keep bliking on and off and the car shuts off. and keeps doing again after u turn it off and back on. does this have to do with the alarm system?

Answer
Yes it does.
Not an uncommon event in this vehicle.
This question comes up A LOT!

The factory system has gone
bad from the sounds of it.

Normally, you would insert the key in
the drivers door, turn left, then right
to disarm and reset it. If yours is malfunctioning,
you can disable it for good by doing the following:

The FACTORY ALARM DISARM WIRE IS
purple/yellow |-| in the driver kick panel area,
at the black plug.

Once Located, splice into this wire with
a simular guage wire, and put it to
a solid chassis ground. This terminates
the alarm functions entirely.

However, at this point, this car would be exceedingly
easy to steel, so I suggest you get an aftermarket
alarm system to protect it from here on in.

Have a good day.

ALARMTEK
CARALARMSTORE.com