Car Alarms: 94 lhs car alarm, side kick panel, negative polarity

Question
I have an 94 LHS I used the power door lock to lock the doors while going into a store.
When I came out I used the key to unlock (lost remote) the doors and the alarm started going off, lights flashing, horn blaring. I tried unlocking different doors, locking again unlocking, nothing worked.
I had to disable the battery to make it stop. After waiting 15 minutes I rehooked the battery but the problem returned, and I tried starting the car but it dies within a few seconds due to motor kill.

Help what can I do to regain use of the car.

Thank You
Brodie

Answer
Ok, the remote is integral to this car.
You can either go to Dodge and replace it,
or disable it totally.

For the latter,
get out some basic install tools or get
a friend or a good technician
in there to do this.

Normally, you would insert the key in
the drivers door, turn left, then right
to disarm and reset it. If yours is malfunctioning,
you can disable it for good by doing the following:

The FACTORY ALARM DISARM WIRE IS
lt.green/orange |20ga - negative polarity|
in the driver's side kick panel.

Once Located, splice into this wire with
a simular guage wire, and put it to
a solid chassis ground. This terminates
the OEM alarm functions entirely.

However, at this point, this car would be exceedingly
easy to steel, so I suggest you get an aftermarket
alarm system to protect it from here on in.

Have a good day.

ALARMTEK
CARALARMSTORE.com