Car Alarms: Seco Enforcer 600 ignition locked, blazer s10, valet service

Question
I have a 94 Blazer s10 with a aftermarket Seco Enforcer 600 alarm unit. The ignition lock have been acting strangely, when turning the ignition switch, I would have to try 3 or 4 times before the starter will engage. But today the lock is permanent. I have tried to arm, then disarm the system with no luck.(keyless remote) I have also tried to disconnect the battery for 30 minutes with no luck. What should I do?

Answer
Gotcha, let's put it into valet/service mode,
and try to reset the alarm to default mode.

Look under the dash area for a button or, a toggle
switch. When you locate it, turn on the ignition
key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.

At this point. the alarm would have reset.
If this had a starter kill relay installed,
it would now be opened, and the engine would
turn over when tried.

You would repeat these steps to go back to
user mode to see if this was corrected.

Let me know if it works for yours.

ALARMTEK
INSTALLSUPPORT.COM