Car Alarms: mx6, fuse box, security light

Question
just replaced engine and transmission. no spark now [checked complete wire system,coil,swaped dist.,tested all ecectronics.] the engine was taken out the bottom. i was just told that it was because the security system was triped. true? thay dont yet have it fully running [now in a box] this is a 94 mx6 or 93 thay sayed thay tricked it by using two keys one in the door one in the ign. has security light in dash, but there was no bells or wissles. does the alarm disconect the ignition? and what is the proper reset? and what happened that triped it?

Answer
Ok, this is what I have on it.
If yours is malfunctioning,
you should be ablt to disable it for
good by doing the following:

The FACTORY ALARM DISARM WIRE IS
yel/rd or lt grn/blk|-  |drivers door harness or
at the security module, built into the fuse box.

Once Located, splice into this wire with
a simular guage wire, and put it to
a solid chassis ground. This terminates
the alarm functions entirely.

However, at this point, this car would be exceedingly
easy to steel, so I suggest you get an aftermarket
alarm system to protect it from here on in.

Have a good day.

ALARMTEK
CARALARMSTORE.com