Car Alarms: 1994 mazda 626 alarm, valet service, dash area

Question
I just bought a 92 626 with no remote and the alarm makes a clicking sound similar to a turn signal randomly while the car is on.  the model is a code alarm rcs-2, how can i stop the sound or disconnect the alarm?

Answer
The siren was probably cut, but the alarm is in
armed mode (the clicking)

Try to put it into valet/service mode,
and try to reset the alarm to default mode.

Look under the dash area for a button or, a toggle
switch. When you locate it, turn on the ignition
key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. (if still installed)

This should over ride the system, and only
the keyless entry part, if installed,
would still be operating.

The LED (light emiting diode) light in the dash
should also go on solid.

At this point. the alarm would have reset.
If this had a starter kill relay installed,
it would now be opened, and the engine would
turn over when tried.

You would repeat these steps to go back to
user mode to see if this was corrected.

Let me know if it works for yours.

ALARMTEK
INSTALLSUPPORT.COM