Car Alarms: MX6 BYPASS FACTORY ALARM\RESET, fuse box, mazda mx6

Question
I have a 94 Mazda MX6 it was standing for a while and the battery went flat, I have charged the battery but now the alarm won't switch off with the remote? is there a way to reset it or bypass it? what is the best way to bypass it? I have read about the yellow/red wire, but then I must start stripping parts?

Answer
Was not clear on what alarm you
are dealing with.

Is it siren & parking light flash or,
car horn honking & headlight flashing?

If it's the latter, then it's
ground the yellow/red or, lt green/black |-|
wires in the drivers door harness or
at the OEM factory alarm built into the fuse
box. Remove what is needed to access the wires
on the back of the fuse box.

This is for a permanant OEM alarm disarm.

If the after market option, see the past
posts to overide.

Good luck.

ALARMTEK