Car Alarms: sensor, valet mode, nissan altima

Question
i have a 2002 nissan altima my sensor that is on the dash for the alarm is not blinking every 3 seconds or at all when the alarm is activated. also if the alarm is activated and i open the door the alarm does not sound

Answer
Hmmm, somehow went into service mode from
the sounds of it.

Should be no problem really.

Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to valet mode.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart for
the vehicle, and reverse engineer it wire
by wire, until it's safely removed.

If it does not work out this way, you will have
to replace the system with one you know how
to operate and what to expect.

Let me know what happens.

ALARMTEK
DELUXESERVICE.com