Car Alarms: Factory Alarm Disengage, autopage remote start, double pulse

Question
I recently bought a AUTOPAGE remote start/ alarm system. The place I took it to to install it forgot to disengage the factory alarm! I am not doing business with them anymore and I am going to complete it myself. Where do I start to disengage my factory alarm on my 2003 Dodge Ram?

Answer
Ok, just a little bit on it for fathers day...
...the FACTORY ALARM DISARM WIRE IS
lt green/orange |-| in the driver kick panel,
This will also do door locks. Arm/lock
is negative trigger thru a 2K ohm resistor. Disarm/unlock is
negative trigger thru a 480 ohm resistor. Single pulse will
do disarm without unlocking the doors. Unlock requires a
double pulse.

MUST use relays. see NEGATIVE TRIGGER DOOR LOCKS @
www.RELAYHELP.com.

From this point on though, you would need to purchase
virtual installer time if you require further
assistance, as this is all the info I am
prepared to offer as a volunteer,
to my competiton's clientel. Sorry but
I make my living online & off, and more
assistance here is a conflict of interest.

I hope you understand.

Good luck with it & Have a good day.

ALARMTEK
CARALARMINSTALLER.com