Car Alarms: 2005 TARUS ALARM, alarmtek, dash area


Question
THE ALARM WILL NOT STOP GOING OFF. IF THE KEY IS IN THE ON POSITION EVERYTHING SEEMS FINE, OTHERWISE THE HORN IS GOING OFF NONE STOP AND THE LIGHTS ARE FLASHING, THE DOORS LOCK AND UNLOCK ALL BY THEMSELVES.
IT IS SO BAD THAT I HAVE TO LEAVE THE BATTERY DISCONNECTED WHENEVER THE CAR IS NOT RUNNING. I HAVE PULLED THE FUSE FOR THE DOOR LOCKS AND UNPLUGGED THE HORN.
WE ARE AFRAID TO DRIVE THE CAR BECAUSE OF FEAR THAT IT IS GOING TO LEAVE US STRANDED.

IS THERE ANYWAY BYPASS, DISCONNECT, OR DISABLE THE SYSTEM??

Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart
(Go to: www.vehiclewires.com)
for the vehicle, and reverse engineer it wire
by wire, until safely removed.

If it does not work out this way,
you will have to replace the system
with one you know how to operate
and what to expect. Don't want to
get stuck in another bad situation.

Let me know what happens.

Robert Martin/CEO-ALARMTEK
DELUXESERVICE.com