Car Alarms: My toyota camry not start, viper 300, toyota camry

Question
Viper 300+ instaled.This car just bought month ago.
Everything fine;Then couple days ago turn the key to start
some sound on the passenger side airbag also some other...
One click like at starter but not any move.
How do I fix it ?
How do I remove anything at alarm system
so I can run my car ?
Thank You.
Son.

Answer
If the starter is making a 'click' noise the alarm is not the cause of your problems.  You probably need a starter or solenoid or similar.  If you want to remove the alarm here is a generic how to on alarm removal:

Typically an alarm system would be installed on the driver's side interior of the vehicle.  This system would have been tapped into the ignition switch wiring running down from the key.  If you remove the dash panel(s) under the steering column you should be able to locate where the harness was added that goes to the alarm.  Disconnect each wire that was tapped in and insulate the factory wiring.  You will also see that at least one of the wires was cut, this is the vehicle starter wire that runs from the key to the starter.  This wire needs to be restored, I always recommend soldering all connections but crimp connectors should also work.  Make sure that you remove all connections to the alarm and that any wires that may be exposed are insulated and mounted in a way that they will not interfere with any moving parts and do not run the risk of shorting out.  Remember to take your time and follow each connection running from the brain of the system, leaving one wire connected that you are unsure of the function could cause problems in the future so be sure to remove every wire.