Car Alarms: Sound in car alarm ( elantra 2007 ), alarmtek, dash area

Question
QUESTION: I have huyndai elantra 2007 with the original car alarm , the problem that the car don't give any sound when closed or opened only flashing , can u help me how to activate sound? thanks for your help
ANSWER: I need to determine whether it's a factory alarm
issue or, if it's an aftermarket system you are
dealing with.

Is it: Headlights flashing, car horn honking
and a worded SECURITY" light in the dash flashing?
Or,
Is it: flashing parking lights,
an LED in the dash area, and a siren
"going off"?

Let me know more on this to better
advise you on a course of action.

Best Regards,

Robert Martin
CEO/ALARMTEK
DELUXESERVICE.com

---------- FOLLOW-UP ----------

QUESTION: It's the factory alarm issue with flashing park lights
the sound was working when i bought the car , & since then i don't know how to make the sound work again
ANSWER: Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.

Let me know what happens.

Robert Martin/CEO-ALARMTEK
DELUXESERVICE.com

---------- FOLLOW-UP ----------

QUESTION: What do u mean by the valet/overide button ?
the lock or the unlock or the open trunk button in the remote keyless entry?

Answer
Tt's a way to disarm your aftermarket alarm.
If not available, you will need to chat with
the hyundai service department on monday,
and have them explain your alarm to you.

Without first hand inspection,
I can't really help too much here.

A.